A heating-oil tank in a Ronkonkoma house answers to three layers of rules: the town the parcel sits in, Suffolk County and New York State. Because Ronkonkoma spans more than one town, the permit side is the part that changes from one of the Ronkonkoma homes to the next.
TL;DR
- The County Clerk's district code list puts Ronkonkoma in three towns: 0200 Brookhaven, 0500 Islip and 0800 Smithtown.
- Brookhaven's permit rule for storage tanks does not apply to heating-only fuel oil tanks of 1,000 gallons or less.
- Islip requires a plumbing or HVAC permit to install or abandon a home heating oil tank, at $160 each, and Smithtown charges $340 per tank.
- The State's Uniform Code sets the steps for abandoning or removing a heating oil tank, including an inspection.
- Question 21 of the State disclosure form asks the seller about fuel storage tanks above or below the ground.
Table of contents
- Which town's rules apply
- The town permit side
- The State abandonment steps
- What the County says
- What the seller's disclosure asks
- Related pages
Which town's rules apply
Ronkonkoma is a hamlet, not a village, so there is no village building department. The Suffolk County Clerk's town and district code list marks Ronkonkoma as lying in multiple townships and gives it three codes: 0200 for Brookhaven, 0500 for Islip and 0800 for Smithtown. Those four digits open the tax map number on the parcel's bill.
The town permit side
- Brookhaven (0200). Section 30-79 of the Brookhaven Town Code requires a permit to install any tank, above or below ground, storing more than 60 gallons of combustible or flammable liquid. It adds that this does not apply to fuel oil tanks of 1,000 gallons' capacity or less that supply heating units only.
- Islip (0500). The Town's permit requirement chart lists a plumbing or HVAC permit for an oil tank, covering installation or abandonment of both underground and aboveground tanks. Its residential fee schedule, effective May 1, 2024, charges $160 each for oil tank demolition, abandonment, replacement or installation.
- Smithtown (0800). The Smithtown Town Code sets the fee for installing or removing storage tanks at $340 per tank.
The State abandonment steps
Subpart 1229-3 of the Uniform Code implements a 2019 change to Executive Law section 378 for heating oil tanks taken out of service. The tank and related piping are emptied, cleaned and purged of all vapor, and the suction, inlet, gauge, vapor return and vapor lines are disconnected. Fill piping is removed or filled with concrete. An underground tank abandoned in place is filled completely with an approved inert solid material, and the owner keeps a written note of the tank size, location and date of abandonment. An aboveground tank is either filled the same way or left with its vent line open and intact. The building official or an approved inspector inspects the abandonment or removal.
When a house converts to another fuel, the owner gives the oil supplier written notice to stop deliveries before the new heating service begins.
What the County says
The County Health Department's storage facility page lists residential heating oil tanks under 1100 gallons, indoors, aboveground outdoors or underground, as exempt from the County permit to construct, and points to Article 12 of the Sanitary Code for the details. The same page says fuel oil tanks do not have to be removed unless they are leaking.
The State's NYSDEC homeowner guide puts removal at $1000 to $5,000, depending on the tank's size, condition and access. It also says that at a sale, a bank or the buyer likely will ask for an environmental assessment or the removal of the tank.
What the seller's disclosure asks
The State's Property Condition Disclosure Statement asks in question 21 whether fuel storage tanks above or below the ground are on the property now or were in the past, whether they are in use, and whether they leak or have leaked. Question 26 asks whether the property has been tested for home heating fuel, with any report attached.
Related pages
More about me.